![]() Press the "Copy" button to copy the result table onto the system clipboard.At the "Compute" tab, press the "CSV" button to produce a comma-separated-values result table.As explained above, create a table of values for a cylindrical tank that has your tank's height (H).You need to download TankCalc and run it locally for this procedure - download here (TankCalc is free).Export the table and paste it into a spreadsheet:.(This approach has the advantage that it correctly takes sensor measurement heights into account.) Use TankCalc to compute a table of results using only the height (H) measurement (divided by 2, then applied as TankCalc's R value), just as though the tank were the red cylinder shown in Figure 2.Measure the tank's height (H) and width (W) in any convenient units.To compute a volume table for a horizontally-mounted oval-cross-section tank, perform these steps: This is possibly the most common inquiry about TankCalc. Update: users may find it easier to analyze this tank type with the new TankProfiler program. ![]() ![]() A table of common material densities can be found in the help file and online as well. Enter the wall thickness and a density for the tank's material. Go to the "Tune" tab and notice the section titled "Surface Area, Mass". Use the corrected measurement values (L',R',r') in TankCalc to compute your tank's internal volume.Īlso, notice that TankCalc can use a tank wall thickness to compute your tank's empty and full weight.L' = L unless the tank has flat end caps that don't extend beyond the end of the tank, in which case L' = L - 2wt.Use the wall thickness to acquire corrected measurements (L',r',r'):.r = radius of the end cap (ellipse minor radius).R = radius of the cylindrical part (ellipse major radius).Measure your tank externally to acquire the three values required by TankCalc (see Figure 1):.Acquire a wall thickness value for your tank.Once we know the tank's wall thickness, we can take external measurements, correct them for wall thickness, and apply them to TankCalc with a reasonable expectation that the volume results will be accurate. For that, we need to take the tank's wall thickness (wt) into account. But the goal is to measure the tank's internal volume, using the outside dimensions. A common error people make using TankCalc is to measure the outside dimensions of a tank and compute a volume on that basis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |